11.4 Layer shift
The printing speed is too fast. Please slow it down.
The belt of X or Y axis is too lose. Please tighten it.
The X or Y axis synchronization wheel is not fixed firmly. Please adjust the eccentric
nuts.
The voltage of the driver of X/Y axis is too low.
11.5 Print stopped
USB printing: the signal is interfered. Please copy the model to TF card and print via TF card.
TF card printing: the gcode file in the TF card is abnormal, please slice again.
The quality of the TF card is poor. Please try another TF card.
The power supply voltage in the area is not stable; please print after the voltage is
stable.
Visit our official forum for more information:
http://www.geeetech.com/forum/viewtopic.php?f=98&t=61864
Shenzhen Getech Technology Co.,Ltd
52