Wire Connection - Geeetech A10T User Manual


Filament holder kit was assembled as shown in Picture (5-6) with 4 M3x16 screws, 4
M3 nuts and 4 M3 washers, a total of 3 sets were assembled.

5.2Wire connection


Insert the three Teflon tubes into the quick-insert connector of the three extruder kits
respectively. Details see picture (5-7).

Insert the LCD cable into LCD socket behind the LCD screen. See picture (5-8).

Connect two sets of power cables
Shenzhen Getech Technology Co.,Ltd
(Picture 5-6)
(Picture 5-8)
(note: can be connected arbitrarily without order)
(Picture 5-7)
10