Loading Filament - Geeetech Mizar S User Manual

1.
Click "Tool"→"Autolevel"→"Z-offset" icon in turn to enter the Z-offset
setting menu (when using the 3D printer for the first time, the
"Z-offset" icon on the Autolevel page is gray, indicating that it is
inoperable, indicating use the user did not enter the "Leveling" page
first to complete the automatic leveling).
2.
After entering the Z-offset interface, click the "Start" icon, and the
hot end will move to the middle of the hot bed. At this time, please
place a piece of A4 paper between the nozzle and the hot bed,
adjust the up and down arrow icons on the interface, and move The
position of the nozzle (on the page, you can adjust the icon for each
motor to move up and down, and the distance the nozzle moves.
When the nozzle is close to the hot bed, it is recommended to switch
to a smaller scale to avoid damaging the nozzle and hot bed), and
move A4 Paper, take A4 paper just rubbed to the nozzle as the best
distance, click the "Save" icon to save the Z-offset parameter, and
complete the adjustment of the distance between the nozzle and the
hot bed.
10
Save
2.
18

LOADING FILAMENT

1. Click "Tool" → "Change" to enter the exchange filament
interface, and then click the "Load" icon. At this time, the
printer will automatically heat the nozzle to 200℃. Before
the nozzle reaches 200℃, the "Load" and "Unload" icons
are disabled, please wait patiently.
Confirm
Heating
After heating the nozzle, the system will remind you to
put the filament into the feed port of the extruder. insert
the filament into the extruder, and then click "Confirm" to
start loading the consumables.
Cancel