Page 2
Copyright Notice This document is copyrighted, May 2000, by Advantech Co., Ltd. All rights are reserved. Advantech Co., Ltd. reserves the right to make improvements to the products described in this manual at any time without notice. No part of this manual may be reproduced, copied, translated, or transmitted in any form or by any means without the prior written permission of Advantech Co., Ltd.
With its rugged, sturdy and well-cooled steel chassis specially designed to withstand heavy shocks and thick dust, the IPC-602 can be used in the harshest of environments. It is ideal for Computer Telephony or network system configurations that require high availability within a limited space, such as computer telephony and networking systems.
Page 5
• EMI: Meets FCC/VDC Class A Environmental specifications • Operating temperature: 0 ~ 45° C (32 ~ 113° F) • Relative humidity: 10 ~ 95% @ 40° C, non-condensing • Safety: UL / CE approved • CE compliant IPC-602 User's Manual...
2.1 Removing the Cover Unscrew the six screws on the front and rear panels , and then slide the cover toward the rear chassis. See Figure 2-1 below: Step 1 Step 2 Step 3 Figure 2-1: Removing the cover IPC-602 User's Manual...
2. Slide the drive bay about 1 cm. toward the rear, to a location where it is not obstructed by the upper rim. Lift it free of the chassis. 3. Remove the cover of the front drive bay, and insert the drives into their proper locations in the drive bay. Figure 2-2: Adding disk drives IPC-602 User's Manual...
Figure 2-3: Installing plug-in cards 2.4 Replacing the Fan Unscrew the two screws on the fan, and slide the cover toward the rear chassis. See Figure 2-4 below: Step 1 Step 2 Figure 2-4: Replacing the fan IPC-602 User's Manual...
2.5 Replacing the Filter The filter is located next to the lockable door. If the IPC-602 is under continuous use, the filter should be changed about once a month. To replace the filter, refer to Figure 2-5 below and do the following: 1.
The sound pressure level at the operator's position according to IEC 704-1:1982 is equal to or less than 70 dB(A). DISCLAIMER: This set of instructions is given according to IEC 704-1. Advantech disclaims all responsibility for the accuracy of any statements contained herein.
Temperaturen das Gerät zerstören könten. Der arbeitsplatzbezogene Schalldruckpegel nach DIN 45 635 Teil 1000 beträgt 70dB(A) oder weiger. DISCLAIMER: This set of instructions is provided according to IEC704-1. Advantech disclaims all responsibility for the accuracy of any statements contained herein.