Selection Of Tip; Servicing And Cleaning Of Airless Hard-Metal Tips; Spray Gun Accessories - WAGNER ProSpray 3.29 Operating Manual

To achieve faultless and rational working, the selection of the tip is of the greatest importance.
In many cases the correct tip can only be determined by means of a spraying test.
Some rules for this:
The spray jet must be even.
If streaks appear in the spray jet the spraying pressure is either too low or the viscosity of the coating material to high.
Remedy
The following principle is valid:
There is a large range of tips with various spraying angles.
Standard tips
The tip has a bore processed with the greatest precision. Careful handling is necessary to achieve long durability. Do not forget the fact that the
The following points must be observed to keep the tip clean and ready for use:
1. Turn the relief valve handle fully counterclockwise (k Circulation).
2. Switch o the gasoline engine.
3. Dismount the tip from the spray gun.
4. Place tip in an appropriate cleaning agent until all coating material residue is dissolved.
5. If there is pressure air, blow out tip.
6. Remove any residue by means of a sharp wooden rod (toothpick).
7. Check the tip with the help of a magnifying glass and, if necessary, repeat points 4 to 6.
Flat jet adjusting tip
Spray width at about 30 cm
Tip
Bore mm
marking
15 0.13 - 0.46
20 0.18 - 0.48
28 0.28 - 0.66
41 0.43 - 0.88
49 0.53 - 1.37
Tip extension
with slewable
knee joint
(without tip)
Length: 100 cm
Length: 200 cm
Length: 300 cm
large tip = low pressure
small tip = high pressure
removal of spray object
5 - 35 cm
5 - 50 cm
8 - 55 cm
10 - 60 cm
10 - 40 cm
GB
Flat jet
Use adjusting tip
Order No.
Paints 0999 057
Paints, llers
0999 053
Paints, dispersions
0999 054
Rust protection paints
0999 055
- dispersions
Large-area coats
0999 056
Tip extension
Contact protection
for the at jet adjustment tip
0097 294
0556 052
0556 053
0556 054
0556 074
0556 075
0556 076
0556 077