Prospray 3.29 / 3.31 Connection Diagram - WAGNER ProSpray 3.29 Operating Manual

Repairs at the unit
lip (2) downward into the upper housing (6).
1
2
13. Place intermediate ring (Fig. 14, Item 10) on the upper packing
(8).
14. Screw threaded joint (Fig. 14, Item 7) into the upper housing
15. Insert lower packing (Fig. 16) in such a way that the side
protruding lip (2) faces upward.
2
1
installation tool.
17. Push installation tool (included in scope of delivery of the
upper packing as a transportation device) for the piston (Fig.
14, Item 4) onto the piston from above.
Blue
Switch
Blue
P/N 0522053
Ground
Surge suppressor
Ground
P/N 0522052
Ground
Brown
Brown
Black
Blue White
P/N 0551758
GB
18. Lubricate installation tool and piston (4) with machine grease.
19. Push piston (4) through the lower and upper packings until
the upper end of the piston protrudes from the threaded joint
(7).
20. Remove installation tool from piston (4).
21. Slide the top of the piston (4) into the T-slot (2) on the slider
assembly (3).
22. Screw lock nut (5) at the upper housing (6) until it touches.
23. Lubricate the threading of the upper housing (6) with
machine grease.
Remove upper housing from the vice.
24. Screw upper housing (6) into the gear unit housing until the
lock nut (5) touches and the connector for the connection
hose faces the rear.
25. Tighten lock nut (5) with light hammer blows.
26. Insert guide ring (11) into the lower housing (Fig. 13, Item 10)
and screw lower housing into upper housing and tighten.
27. Screw on and tighten connection hose.
28. Screw in inlet valve housing (Fig. 12, item 2), see Chapter 11.2,
Item 13.
29. Screw on and tighten suction tube.
30. Fasten return hose with clamp at suction tube.
31. Install front cover.
EMI Filter
Fuse block
Fuse
Black
Red
Black
White
Red
Black
Motor
38
Power Cord
Capacitor
Red (+)
Black (-)
Motor controller
L.E.D.
Hall sensor
Potentiometer
Display wire assembly
(P/N 0522022)
Pressure sensor