Installation Of Fire; Unpacking The Fire; Installing The Fire Box - Flavel Ora Installation And Maintenance Instructions Manual

INSTALLATION OF FIRE

2.1

UNPACKING THE FIRE

Carefully lift the fire out of the carton. Remove the loose item packaging carefully
from the front of the appliance. Check the contents as listed :-
Packing Check List
1 off Fire box / burner assembly
1 off Boxed ceramic base, front ceramic rail and fire bed and 22 synthetic
coals (2 small, 20 large), 1 off fuelbed insulation mat.
1 off each User instruction book and Installation book
1 off Trim (attached to appliance on Ora / Aluma models, packed on Toccata)
1 off Flue restrictor baffle (for use in brick built chimneys and large diameter
e.g. 175mm flue applications).
Fixing Kit Check List
2 off Fixing cables
4 off Wallplugs
4 off Eyebolts
2 off Tensioner bolts & nuts
2 off Tensioner screws
2 off Fender fixing screws
2 off Fender fixing brackets (L/H & R/H)
Fender Box
1 off Fender & Ashpan Cover
2.2

INSTALLING THE FIRE BOX

Establish which type of flue you are intending to install the fire in to :-
225 x 225mm (9 inch x 9 inch) brick built chimneys
175mm (7 inch) diameter lined brick or stone flue, or insulated pre-fabricated
metal flue box to B.S. 715.
When installing into 125mm (5 inch) diameter lined brick or stone flue, or
insulated pre-fabricated metal flue box to B.S. 715 and pre-cast flues the
restrictor baffle must not be fitted.
A spillage test must always be carried out to check satisfactory
clearance of flue products, regardless of the type of flue the
appliance is being fitted to.
SECTION 2
10