Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Proxxon FET
Summary of Contents for Proxxon FET
- Page 1 Manual...
- Page 2 Fig. 2 Fig. 1 Fig. 3 Fig. 4 Fig. 5 Fig. 5a Fig. 6...
- Page 3 Fig. 7 Fig. 8a Fig. 9 Fig. 8b Fig. 10b Fig. 10a...
- Page 4 Fig. 11 Fig. 10c Fig. 12 Fig. 13 Fig. 14...
-
Page 5: Table Of Contents
Safety guidelines for operating table saws with the instructions. Description of machine PROXXON will not be liable for the safe function of the device for: Legend (fig. 1) Technical data • handling that does not comply with the usual intended use, •... -
Page 6: Safety Guidelines Regarding Protective Covers
• Wear hearing protection! Exposure to noise can cause hear- 2.3 Safety guidelines for sawing process ing loss! Make sure that the machine and its accessory parts are in technically perfect condition! Only the above a) DANGER: Your fingers and hands should not come establishes the optimal conditions for noise reduction. -
Page 7: Kickback - Causes And Corresponding Safety Guidelines
l) For long sections on work pieces which are thinner j. If you want to restart a saw whose saw blade is still in than 2 mm, use an additional parallel limit stop that has a work piece, centre the saw blade in the sawing gap contact with the table surface. -
Page 8: Description Of Machine
3. Description of machine 4. Legend (fig. 1) 1. Saw blade guard The FET table saw is a well thought-out machine for all occur- 2. Saw table ring sawing tasks in the range of small and fine applications. 3. Saw blade A powerful motor, solid mechanics, high-quality materials and 4. -
Page 9: Setting Up The Saw
Only use in the house ideally on a heavy workbench or a solid table. To obtain a secure hold, your FET should be screwed to the surface: For Do not dispose of the device in this purpose there are four holes in the housing bottom so that household waste fastening screws can be screwed into them. -
Page 10: Saw Blade Guard
Your FET is equipped with a saw blade guard. It is designed in 3. After the desired position is achieved, retighten the knurled such a way that moves up as far as necessary during sawing button 1. -
Page 11: Working With The Limit Stops
Stand in front of the saw while sawing! Never saw with your Adjusting the zero position of the limit stop scale: FET from the side or even from the back. Ensure sufficient sta- bility while you work! 1. Align the longitudinal stop with the left edge 6 over the zero mark of the scale (alternatively left or right). -
Page 12: General Tips On Sawing
• Only use perfect saw blades. Make sure that the saw blades shaft shoulder! are suitable for use with the FET. You must comply with the 7. Please also make sure that the teeth are pointing in the dimensions specified in the technical data. -
Page 13: Cleaning The Housing
L-6868 Wecker possibly moist cloth. A soft detergent or other suitable cleaning agent may be used. Avoid using solvents or alcohol-based Product designation: Fine cut circular saw FET cleaning agents (e.g. benzine, rubbing alcohol, etc.) as these Article No.: 27070 will affect the plastic housing shells. - Page 14 Ersatzteilbild...
- Page 15 Spare Parts List...
- Page 16 Fig. 14a Fig. 14b Fig. 16a Fig. 15 Fig. 16b Fig. 17...
- Page 17 Service note All PROXXON products are thoroughly inspected after production. Should a defect occur nevertheless, please contact the dealer from whom you purchased the product. Only the dealer is responsible for handling all legal warranty claims which refer exclusively to material and manufacturer error.
Need help?
Do you have a question about the FET and is the answer not in the manual?
Questions and answers