Operating Instructions Safety Instructions; Important Notes - Truma iNet X Operating Instructions Manual

Operating instructions
Safety instructions
– The Truma iNet X must not be operated unless it is in tech-
nically perfect condition.
– Repairs must be carried out immediately. Only carry out
repairs yourself if the solution is described in the trouble-
shooting guide of the control panel or the App.
– Do not repair or modify the Truma iNet X.
– A defective Truma iNet X may only be repaired by the man-
ufacturer or the manufacturer's service department.
– Never use LP gas appliances when refuelling, in multi-storey
car parks, in garages or on ferries. Switch off the Truma iNet X
to prevent the heater being switched back on by the
Truma App or the time switch (see "Switching on/off").
– Do not switch on the appliance if the housing is damaged
or if liquid has entered it.

Important notes

– If a new or replacement appliance (heater, air conditioning
system) is connected to the bus system, the procedure de-
scribed in "Initial start-up" must be repeated.
– In case of problems, the appliance is reset to the last func-
tioning version.
Air conditioning systems – joint use of IR remote con-
trol and Truma iNet X
– Even when the Truma iNet X has been connected, the IR
remote control is still available to control the air condi-
tioning system. The Truma iNet X recognises all settings
that are made on the air conditioning system using the
IR remote control. The IR remote control only transmits
the settings that are shown in its display (no bidirectional
communication).
– Only the time switch of the Truma iNet X may be used to
define the start and end time of a required period.
– This device corresponds to Section 15 of the FCC reg-
ulations and the RSS standards of Industry Canada for
licence-exempt radio devices. For operation, the following
conditions must be fulfilled:
(1) The device must not cause any damaging interference.
(2) The device must be immune to interference, also inter-
ference that could cause unwanted operating states.
– This device complies with Part 15 of the FCC Rules and
contains licence-exempt transmitter(s)/receiver(s) that com-
ply with Innovation, Science and Economic Development
Canada's licence-exempt RSS(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including inter-
ference that may cause undesired operation of the device.
– L'émetteur/récepteur exempt de licence contenu dans
le pré-sent appareil est conforme aux CNR d'Innovation,
Sciences et Développement économique Canada applica-
bles aux appa-reils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est sus-ceptible
d'en compromettre le fonctionnement.
EN 3