Table 34 Types of associated nodes and their key parameters
Node type
FTN
ILM
LPW
VPW
FRR
INN
OAM
BFD
display mpls route-state
Use display mpls route-state to display LSP information for routes.
Syntax
display mpls route-state [ vpn-instance vpn-instance-name ] [ dest-addr mask-length ] [ | { begin |
exclude | include } regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
vpn-instance vpn-instance-name: Displays LSP information for the routes on the specified VPN. The
vpn-instance-name argument is the instance name of an MPLS L3VPN, a case-sensitive string of 1 to 31
characters.
dest-addr mask-length: Displays LSP information for routes to a destination address. dest-addr is the
destination IP address. The mask length is in the range of 0 to 32.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
FEC to NHLFE mapping.
Incoming label mapping.
Sending entries of VPWS PW.
Sending entries of VPLS PW.
Primary NHLFE of FRR.
Inner-layer NHLFE of layered LSP.
Check through OAM the connectivity of
the CR-LSP corresponding to the NHLFE.
Check the connectivity of the NHLFE
through BFD.
74
Key parameter
•
VPN ID—VPN instance ID.
•
Address prefix/mask.
•
In-Label—Incoming label.
•
In-If—Incoming interface.
•
SRV ID—Service instance ID.
•
Private-If—Private network interface.
•
VSI ID—Virtual switching instance ID.
•
Link ID.
Token—Token of the primary NHLFE.
Token—Token of the inner NHLFE.
Index—OAM instance index.
BFD Discr—Local discriminator value of
the BFD session.