Mpls Rsvp-Te Bfd Enable; Mpls Rsvp-Te Blockade-Multiplier - H3C S5820X Series Command Reference Manual

interface to authenticate received RSVP messages. For the two interfaces at the two ends of a link to
exchange RSVP messages, they must share the same authentication key.
This hop-by-hop authentication of RSVP prevents fake resource reservation requests from occupying
network resources.
Examples
# Enable RSVP authentication on VLAN-interface 1, and set a plaintext key of userkey1.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] mpls rsvp-te authentication plain userkey1

mpls rsvp-te bfd enable

Use mpls rsvp-te bfd enable on an RSVP-TE enabled interface to enable BFD for link detection.
Use undo mpls rsvp-te bfd enable to disable BFD on an RSVP-TE enabled interface.
Syntax
mpls rsvp-te bfd enable
undo mpls rsvp-te bfd enable
Default
BFD for link detection is not enabled on an RSVP-TE enabled interface.
Views
Interface view
Default command level
2: System level
Usage guidelines
Before enabling BFD for link detection on an interface, make sure the interface is enabled with RSVP-TE.
Examples
# Enable BFD link detection on RSVP-TE enabled interface VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] mpls rsvp-te bfd enable

mpls rsvp-te blockade-multiplier

Use mpls rsvp-te blockade-multiplier to configure the blockade multiplier, which determines the timeout
time of blockade state.
Use undo mpls rsvp-te blockade-multiplier to restore the default.
Syntax
mpls rsvp-te blockade-multiplier number
undo mpls rsvp-te blockade-multiplier
161