The Passage Automatically 3° Cooler Than The Office - Velbus VMB1TC Manual

The passage automatically 3° cooler than the office
When the sensor module in the office is set to day-mode, the temperature in the passage must be 3° lower than the
office. Is the day temperature of the office is set to 20°C the desired passage temperature will be 17°C.
When the sensor module in the office is set to night-mode, the temperature in the passage must be 3° lower than the
office. Is the night temperature of the office is set to 15°C the desired passage temperature will be 12°C.
Office
Configuration:
The easiest way to configure the system is to use the Velbus link program via a PC connected on the Velbus PC interface
(VMB1USB, VMB1RS of VMBRSUSB).
However, configuration can also be done without the aid of a computer. Refer to the procedure below.
Link the heating output of the office sensor to a relay channel (ex. channel1).
1. Set the office sensor module in anti-freeze mode by
pressing the push button on the front panel
repeatedly until all LEDs are off.
2. Set the MODE and TIME1 rotary switches for
channel 1 of the second relay module to '0' (instant
control).
VMB1TC Temperature controller manual – rev 5.0
3. Remember the address of this relay module to
reinstate it later on.
4. Set the address of the relay module to 'C1'. The
'MODE 1' LED flashes to indicate push button
learning mode (PBM).
Out1 Out2
Mode/ Mode/ Mode/ Mode/
ADDR. ADDR. Time2 Time2 Time2 Time2
0 0 0
Time1 Time1 Time1
0 0 0
Learn
CH1 CH2
Fx : OFF
x=CH1...4
Ex : ON
: : 9x :
Dx TGL Bx TG1 ST1
Cx : PBM Ax : TG2 8x : ST2
ON Rx Tx Mode1
Passage
Out3 Out4
4 Channel relay module
Mode/
Time2 Time1 Mode/Time2
0 0 0:Moment Start-stop
1:5s Staircase
2:10s Non-Retrigger
3:15s Turn Off Delay
4:30s Turn On Delay
5:1' Trig Release
Time1
6:2' Blink
0 0
7:5' 5'
8:10' 10'
9:15' 15'
A:30' 30'
CH3 CH4 B:1h 1h
C:2h 2h
VMB4RY D:5h 5h
velleman E:1day 1day
F:Toggle Toggle
Mode2 Mode3 Mode4
95