Recall And Change The Desired Temperature; Temporarily Switching Between Comfort, Day, Night Or Anti-Freeze Mode - Velbus VMB1TC Manual

Recall and change the desired temperature

At any time the desired temperature for a room can be shown and/or changed.
1. Press the ↑ or ↓ button.
The desired temperature for the selected room is flashing on the display.
T
Location
Li v i ng r oom
Tar get
Mode Menu
← →
2. When desired, change the target temperature with the ↑ or ↓ button.
Location T
Li v i ng r oom
Tar get
Mode Menu
← →
3. Return to normal display by pressing the T or ← button or simply wait for ±5 seconds without touching any button.
T
Location
Li v i ng r oom
M o 14: 23 21
Mode
←
Remark:
When switching between anti-freeze, night, day or comfort mode the target temperature will be replaced by the desired
temperature that is linked to each mode.

Temporarily switching between comfort, day, night or anti-freeze mode

In rooms equipped with a temperature sensor VMB1TS, the heating (or cooling) can be set to 4 modes (comfort
, night or anti-freeze - ). Every mode has a preferred temperature setting.
The heating (or cooling) can be forced temporarily (sleep timer) into a certain mode. During that time, all program
instructions will be ignored. Once the timer expires the normal program is resumed or when no program was active the
device returns to the previous mode.
This could be useful e.g. to switch the heating of the bathroom to comfort mode for an hour.
Temporarily switching between the different modes is done by pushing the push button on the temperature sensor
VMB1TS or via this module.
74
↑
___
↓
↑
21
↓
↑
Menu
↓
→
VMB1TC Temperatuurcontroller handleiding – rev 5.0
, day