Table of Contents
Advertisement
Defining zones
It could be interesting to group different sensors in a zone. When that zone is selected, all operations on the controller will
be applicable for all sensors that belong to that zone. This way operating the system can be greatly facilitated.
It is possible to define up to 7 zones e.g. ground floor, second floor, bedrooms ...
Default temperature sensors are not assigned to a zone. To assign them to a zone the procedure below should be
followed.
1. Press the 'Location' button repeatedly until the
sensor that will to be added to a zone is displayed.
Location
T
Bedr oom 1
M o 14: 32 16
Mode
←
2. Press and hold the 'Menu' button for ±4 seconds to
open the extended menu.
Location
T
Bedr oom 1
Pr ogr am
Mode
Menu
←
→
3. Scroll through the extended menu using the ↑ or ↓
button until the 'Sensor settings' item appears.
T
Location
Bedr oom 1
Sens or s et t i ngs
Mode
Menu
←
→
4. Select the sensor settings menu with the → button.
T
Location
Bedr oom 1
Oper at i ng m ode
Mode
Menu
←
→
↑
Menu
↓
→
↑
↓
↑
↓
↑
↓
VMB1TC Temperature controller manual – rev 5.0
5. Scroll through the sensor settings menu using the ↑
or ↓ button until the 'Zone number' item appears
Location
T
Bedr oom 1
Zone num ber
Mode
Menu
←
→
6. Select the zone number menu with the → button.
T
Location
Bedr oom 1
________
Mode
Menu
←
→
7. Change the zone with the ↑ or ↓ button.
Option '---' indicates that the sensor does not belong
to a zone.
T
Location
Bedr oom
Zone 1
Mode
Menu
←
→
8. Confirm with the → button.
Location
T
Bedr oom 1
Zone num ber
Mode
Menu
←
→
↑
↓
↑
↓
↑
↓
↑
↓
49
Advertisement
Table of Contents
