Entering A New Program Instruction - Velbus VMB1TC Manual

Entering a new program instruction

1. Press the 'Location' button repeatedly until the room
or zone of which a program instruction needs to be
added is displayed.
Location T
Li v i ng r oom
M o 14: 47 22
Mode
←
2. Press and hold the 'Menu' button for ±4 seconds to
open the extended menu. Enter the PIN code if
necessary.
Location T
Li v i ng r oom
Pr ogr am
Mode Menu
← →
3. Select the program menu with the → button.
The display shows the first program instruction.
T
Location
Li v i ng r oom
M o- Su 22: 30
Mode Menu
← →
Remark:
When no instructions are entered yet, the line will be
empty. Skip step 4 and proceed with step 5.
4. Scroll through the program instructions using the ↑
button until the instruction line is empty.
Location T
Li v i ng r oom
- -
Mode Menu
← →
↑
Menu ↓
→
↑
↓
↑
↓
↑
↓
VMB1TC Temperature controller manual – rev 5.0
5. Press the → button to add an instruction.
The first data entry field flashes.
T
Location
Li v i ng r oom
_____
Mode Menu
← →
6. Use the ↑ or ↓ button to set the day(s) on which the
instruction needs to be executed. Confirm with the →
button.
Location T
Li v i ng r oom
M o- Fr _ 0: 00
Mode Menu
← →
7. Use the ↑ or ↓ button to set the time reference
(exact, relative to wake-up or go-to-bed time) on
which the instruction needs to be executed. Confirm
with the → button.
Location T
Li v i ng r oom
M o- Fr __: 00
Mode Menu
← →
8. Change the program time with the ↑ or ↓ button and
confirm with the → button.
T
Location
Li v i ng r oom
M o- Fr 6: __
Mode Menu
← →
Remark:
In case the wake-up or go-to-bed time is selected as
reference, the offset can be set per 15 minutes with a
limit of 4 hours. Step 9 is not applicable.
↑
↓
↑
↓
↑
↓
↑
↓
89