Checking And Adjustment After Installation - Sony DFP-R3000 Installation Manual

Sdds player system digital film sound reader.

Hide thumbs Also See for DFP-R3000:

Quick start manual (100 pages)

Operation manual (17 pages)

Quick start manual (23 pages)

Table Of Contents

Table of Contents

Enlarged version

Step 2. Installing the DFP-R3000 to the Projector

1. Attach the optional guide (35 mm) to the DFP-R3000

with hexagon cap screw (4 x 10), plane washer and

spring washer (SW4).

2. Install the DFP-R3000 tentatively in the adapter(A)

with four hexagon cap screws (M4 x 12) 4, four

washer (W4) and four spring washers (SW4).

3. Put the film on the projector from the DFP-R3000 and

adjust the position (arrow direction A) of DFP-R3000

so that the film is smoothly fed onto the projector.

4. After the adjustment has been completed, tighten the

four hexagon cap screws (M4 x 12) 4.

5. Reattach the REEL ARM of the projector tentatively

to the DFP-R3000 with two hexagon cap screws (3/8-

16) 5.

Fixing hole position of the DFP-R3000 varies depend-

ing on the REEL ARM to be used.

6. Set the film to the DFP-R3000 from the REEL ARM,

and adjust the installation position of the REEL ARM

so that the film runs smoothly and the tension on both

edges of the film is even.

7. After the adjustment has been completed, tighten the

two hexagon cap screws (3/8-16) 5.

8. Connect the DFP-R3000 to the DFP-D3000.

(Refer to "5-3. Connection to the DFP-D3000".)

9. After the connection is completed, perform "5-4.