Sony DFP-R3000 Installation Manual page 13

6. Put a film on the path adjustment tool (roller) from the
projector, and adjust the attaching position of the path
adjustment tool so that the film is smoothly fed onto
the projector.
7. After the adjustment has been completed, tighten the
two hexagon cap screws (M4 x 12) 3.
8. Put a film on the path adjustment tool (roller) from the
projector, and adjust the attaching position of the
adapter (A) so that the film is smoothly fed onto the
projector.
Especially adjust so that the tension on both edges of
the film is even.
9. After the adjustment has been completed, tighten the
two hexagon cap screws (3/8-16) 2.
10. Remove the film from the path adjustment tool.
11. Remove the path adjustment tool from the adapter (A).
Step 2. Installing the DFP-R3000 to the Projector
1. Install the DFP-R3000 tentatively in the adapter(A)
with four hexagon cap screws (M4 x 12) 4, four
washers (W4) and four spring washers (SW4).
2. Put the film on the projector from the DFP-R3000 and
adjust the position (arrow direction A) of DFP-R3000
so that the film is smoothly fed onto the projector.
3. After the adjustment has been completed, tighten the
four hexagon cap screws (M4 x 12) 4.
4. Reattach the REEL ARM of the projector tentatively
to the DFP-R3000 with two hexagon cap screws (3/8-
16) 5.
n
Fixing hole position of the DFP-R3000 varies depend-
ing on the REEL ARM to be used.
5. Set the film to the DFP-R3000 from the REEL ARM,
and adjust the installation position of the REEL ARM
so that the film runs smoothly and the tension on both
edges of the film is even.
6. After the adjustment has been completed, tighten the
two hexagon cap screws (3/8-16) 6.
7. Connect the DFP-R3000 to the DFP-D3000.
(Refer to "5-3. Connection to the DFP-D3000".)
8. After the connection is completed, perform "5-4.
Checking and Adjustment After Installation".
DFP-R3000
Film
5 Hxagon cap screw
(3/8-16)
Spring washer
Washer
(W4)
Washer (W4)
Spring washer
(SW4)
4 Hexagon cap screw (M4 x 12)
Optional guide (E)
4
Hexagon cap screw (M4 x 12)
Path adjustment tool
Adapter (A)
Projector
SIMPLEX 35
5
REEL ARM
DFP-R3000
4 Hexagon cap screw
(SW4)
(M4 x 12)
A
Washer (W4)
Adapter (A)
Washer (W4)
Spring washer (SW4)
Projector
SIMPLEX 35
1-9 (E)