Sony DFP-R3000 Installation Manual page 23

Step 2. Installing the DFP-R3000 to the Projector
1. Attach the adapter (B) to the DFP-R3000 with two
screws (PSW4 x 12) 3.
2. Install the DFP-R3000 tentatively in the adapter (A)
with four hexagon cap screws (M4 x 12) 4, four
washers (W4) and four spring washers (SW4).
3. Put the film on the projector from the DFP-R3000 and
adjust the position (arrow direction A) of DFP-R3000
so that the film is smoothly fed onto the projector.
4. After the adjustment has been completed, tighten the
four hexagon cap screws (M4 x 12) 4.
5. Reattach the REEL ARM of the projector tentatively
to the DFP-R3000 with three hexagon cap screws (5/
16) 5.
n
Fixing hole position of the DFP-R3000 varies depend-
ing on the REEL ARM to be used.
6. Set the film to the DFP-R3000 from the REEL ARM,
and adjust the installation position of the REEL ARM
so that the film runs smoothly and the tension on both
edges of the film is even.
7. After the adjustment has been completed, tighten the
three hexagon cap screws (5/16) 5.
8. Connect the DFP-R3000 to the DFP-D3000.
(Refer to "5-3. Connection to the DFP-D3000".)
9. After the connection is completed, perform "5-4.
Checking and Adjustment After Installation".
DFP-R3000
5 Hxagon cap screw (5/16)
REEL ARM
DFP-R3000
Washer (W4)
Washer (W4)
4 Hexagon cap screw
Spring washer (SW4)
(M4 x 12)
5
5
3
PSW4 x 12
3
PSW
4 x 12
Adapter (B)
4
Hexagon cap
screw (M4 x 12)
Spring washer
(SW4)
Washer (W4)
Adapter (EA)
Projector
NORELCO
AA-II 35/70
1-19 (E)