Sony DFP-R3000 Installation Manual page 16

Step 2. Installing the DFP-R3000 to the Projector
1. Install the DFP-R3000 tentatively in the adapter (EA)
with four hexagon cap screws (M4 x 12) 4, four
washers (W4) and four spring washers (SW4).
2. Put the film on the projector from the DFP-R3000 and
adjust the position of DFP-R3000 so that the film is
smoothly fed onto the projector.
3. After the adjustment has been completed, tighten the
four hexagon cap screws (M4 x 12) 4.
4. Reattach the REEL ARM of the projector tentatively
to the DFP-R3000 with two hexagon cap screws (3/8)
5.
n
Fixing hole position of the DFP-R3000 varies depend-
ing on the REEL ARM to be used.
5. Set the film to the DFP-R3000 from the REEL ARM,
and adjust the installation position of the REEL ARM
so that the film runs smoothly and the tension on both
edges of the film is even.
6. After the adjustment has been completed, tighten the
two hexagon cap screws (3/8) 6.
7. Paste the label as shown as A or B according to the
film-path direction.
8. Connect the DFP-R3000 to the DFP-D3000.
(Refer to "5-3. Connection to the DFP-D3000".)
9. After the connection is completed, perform "5-4.
Checking and Adjustment After Installation".
1-12 (E)
Hxagon cap screw
(3/8) 5
4
Hexagon cap screw (M4 x 12)
Spring washer (SW4)
Spring washer (SW4)
Washer (W4)
Washer (W4)
Spring washer (SW4)
4 Hexagon cap screw (M4 x 12)
A
Adapter (EA)
Label
B
Adapter (EA)
5
REEL ARM
DFP-R3000
Washer (W4)
Adapter (EA)
Projector
SIMPLEX 35
Label
Label
Label
DFP-R3000