Step 3: Install The Controller And Software; System Requirements - Keysight Technologies M9260A Startup Manual

1 Inspection, Installation, and Verification

Step 3: Install the Controller and Software

System requirements

The following table lists the minimum system requirements for Keysight IO
Libraries Suite and controllers. In general, any x86 or x64 (except Itanium)
architecture should work but there may be a significant decrease in performance if
the processor speed is below the minimum requirements.
Table 1-1 System requirements
Operating system
Processor speed
Available memory
Available hard-d isk
[a]
space
Display Resolution
Input Device
Browser
Chassis
Embedded Controller
Remote Controller
[a] Because of the installation proced ures, less memory may be required for the operation than is required for the
installation.
24
®
Windows 7 SP1 (32 or 64-bit) or higher
– 1.5 GHz (x86 and x64) or higher
– Itanium 64 is not supported
2 GB minimum
2 GB available hard-disk space
1024 × 768
Mouse or a compatible pointing device
®
Microsoft Internet Explorer 7 or greater
A PXIe or PXI-H chassis peripheral slot
A Keysight embedded controller running one of the above operating systems.
Note: The embedded controller must be compatible with the Keysight chassis.
A desktop/laptop PC running one of the above operating systems and a Keysight interface cable
(e.g. Y1202) with PCIe (desktop) or ExpressCard (laptop) interface card.
Keysight M9260A Startup Guide