Siemens SITRANS RD200 Operating Instructions Manual page 30

Setup
6.3 Setting decimal point
Setting fail-safe operation (FLSF: FLS1, FLS2)
The fail-safe operation is set independently for each relay. Select
to disable fail-safe operation.
Set up relays for fail-safe operation:
1. Press Menu
2. Press Enter/Ack
3. Press Up arrow
4. Press Enter/Ack
5. Press Up arrow
6. Press Enter/Ack
7. Press Enter/Ack
8. Press the Up arrow
9. Press Enter/Ack
10. Press Enter/Ack
to exit and return to Run Mode.
Once the Fail-Safe operation has been enabled, under normal conditions, the relays are on,
and under alarm conditions, the relays are off. (Notice that the functionality of the relays is
reversed when the Fail-Safe operation is disabled.)
Programming time delay (dLA: dLy1, dLy2)
The
seconds. The relays will transfer only after the condition has been maintained for the
corresponding time delay.
The
The
Set up relay on and off time delays:
1. Press Menu
2. Press Enter/Ack
3. Press Up
4. Press Enter/Ack
5. Press Up
6. Press Enter/Ack
7. Press Enter/Ack
8. Press Enter/Ack
9. Press Up
10. Press Enter/Ack
30
to enter Program Mode.
to access the Setup menu.
until rELy is displayed.
to enter Relay menu.
until FLSF is displayed.
to access Fail-Safe Menu. FLS1 is displayed.
to set up fail-safe feature for relay 1.
to accept settings. FLS2 is displayed.
to set up fail-safe feature for relay 2 as in steps 7-9, or press Menu
On OFF
and time delays may be programmed for each relay between 0 and 199
On
time delay is associated with the set point.
OFF
time delay is associated with the reset point.
to enter Program Mode.
to access the Setup menu.
arrow until rELy is displayed.
to enter Relay menu.
arrow until dLAy is displayed.
to enter Time Delay Menu. dLy1 is displayed.
to set time delay for relay 1. On1 is displayed.
to proceed.
arrow to change digit and Right arrow to change active digit.
to accept setting.
to switch on or off.
on
to enable or select
Operating Instructions, 05/2019, A5E47629414-AA
off
SITRANS RD200