Connection; Connector Labeling - Siemens SITRANS RD200 Operating Instructions Manual

Communication and displays.

Hide thumbs Also See for SITRANS RD200:

Table of Contents

Connection

Wiring requirements

• Use copper wire with +60 °C or +60/75 °C (+140 °F or +140/167 °F) insulation for all line

• Observe all safety regulations.

• Electrical wiring should be performed in accordance with all applicable national, state,

Note

• Verify that all system components are installed in accordance with instructions.

• All connections are made to removable screw terminal connectors located at the rear of

the meter.

5.1

The connectors label, affixed to the meter, shows the location of all connectors available with

requested configuration. It also identifies the location of the RTD/TC selector switch.

Connector Labeling for Two Relays and 24 V Supply

WARNING

voltage connections.

and local codes to prevent damage to the meter and ensure personnel safety.

Operating Instructions, 05/2019, A5E47629414-AA

SITRANS RD200

Table of Contents