Table of Contents
Advertisement
Setup
6.1 Main menu
FLS2
dLAy
dLy1
On1
OFF1
dLy2
On2
OFF2
Aout
SEbr
out1
out2
ProG
ScAL
CAL
inP1
diS1
inP2
diS2
err
PASS
unLC
LoCd
9999 -1999
open
6.1
Main menu
The main menu includes the most common functions: Setup, Program, and Password.
Press Menu
main menu options; Setup (SEtu ), Program (ProG ), and Password (PASS ).
Press Menu
prior to pressing Enter/Ack
Changes to the settings are saved only after pressing Enter/Ack
The display moves to the next menu every time a setting is accepted by pressing Enter/Ack
24
Fail-safe2
Set relay 2 fail-safe operation
Delay
Enter Time delay menu
Delay1
Enter relay 1 time delay setup
On1
Set relay 1 on time delay
Off1
Set relay 1 off time delay
Delay2
Enter relay 2 time delay setup
On2
Set relay 2 on time delay
Off2
Set relay 2 off time delay
Analog Output
Enter the Analog Output menu
Sensor break
Program TC or RTD sensor break value for analog out
Output 1
Program output 1 value (e.g. 4 mA)
Output 2
Program output 2 value (e.g. 20 mA)
Program
Enter the Program menu
Scale
Enter the Scale menu
Calibrate
Enter the Calibrate menu
Input 1
Calibrate input 1 signal or program input 1 value
Display 1
Program display 1 value
Input 2
Calibrate input 2 signal or program input 2 value
Display 2
Program display 2 value
Error
Error, calibration not successful, check signal
Password
Enter the Password menu
Unlocked
Program password to lock meter
Locked
Enter password to unlock meter
Flashing display
Overrange condition
Underrange condition
Open TC or RTD sensor
to enter Program Mode then press Up arrow
at any time to exit and return to Run Mode. Changes made to settings
are not saved.
to scroll through the
Operating Instructions, 05/2019, A5E47629414-AA
SITRANS RD200
Advertisement
Table of Contents
Troubleshooting
