Table of Contents
Advertisement
3.2.5 Communication Setup Screen
Use this Setup screen (Figure 3-9) to choose the leak detector that the wireless remote is
associated with, if there is more than one potential leak detector host. The first choice allows you
to select a wireless remote from the known list of available leak detectors. The second choice
allows you to search for all available leak detectors and present a selection list of leak detector
MAC sub-addresses.
Use this screen to navigate to the three sub-screens to:
Use the SELECT screen to choose a leak detector from a list of leak detectors within
•
communications range that are is not already connected. While up to 10 leak detectors
MAC addresses can be configured at one time, only one connection can be active (page 3-
14).
Use the Search screen to scan the area for available leak detector RF channels (from 1 to
•
19) and then choose a leak detector from a list of leak detectors within communications
range (page 3-17).
Use the MAC addresses screen to verify the leak detector and wireless remote addresses
•
(page 3-19).
Wireless Remote for Agilent Helium Leak Detector
Figure 3-9. Communications Setup - Initial
3-13
Advertisement
Table of Contents
