Startup And Shutdown; Startup; Shutdown; Operating The Wireless Remote - Agilent Technologies VS G8600-60002 Operation Manual

3 3 3 3 Operating the Wireless Remote

Operating the Wireless Remote Operating the Wireless Remote Operating the Wireless Remote

3.1 Startup and Shutdown

3.1.1 Startup

To start the wireless remote unit:
Battery powered:
Press the ON
•
External wall-mount plug-in or desktop AC/DC power supply powered
a) Plug the wall-mount plug-in unit or desktop's leak detector power cord into an appropriate
mains power voltage supply receptacle.
b) Insert a 2.5 mm barrel type plug into the DC input of the wireless remote.
c) Press the ON
If the wireless remote was:
Connected in a session to a leak detector at the previous power-down, and it can connect
•
to the same leak detector again, then the remote's display transitions to the HOME screen.
Not connected at the previous power-down, or it can no longer establish a session with the
•
same leak detector, the remote goes into Searching mode. Searching mode is also
accessed manually via the Setup screen.
Note

3.1.2 Shutdown

The wireless remote can be in any mode when shut down.
To shut down the wireless remote:
Push and hold the OFF
•
Wireless Remote for Agilent Helium Leak Detector
ON button
ON ON
ON button.
ON ON
The term session, used in the operational descriptions, refers to an
established, exclusive point-to-point link between the wireless remote
and a leak detector.
OFF button until the LCD display and audio signal go off OFF OFF
3-4