3.2.3 Speaker Volume Setup Screen
Use this screen to setup the desired level of the volume when the speaker is turned on.
Audio
Audio
Audio
Audio
Volume
Volume
Volume
Volume
To set the volume:
1. Press the
Enter
Enter and the Speaker Volume setup screen appears (Figure 3-4).
Enter
Enter
2. Press Enter
Enter and the configuration screen appears (Figure 3-5).
Enter
Enter
3. Press the
4. Press Enter
Enter and Figure 3-4 reappears.
Enter
Enter
5. Press the
screen reappears.
Wireless Remote for Agilent Helium Leak Detector
When the leak rate bar graph display is set to Linear mode:
The audio signal increases from a low to high frequency as the
•
leak rate increases within each decade
The pitch cycles low to high as it passes through each decade.
•
The audio response corresponds directly to the size of the leak.
,
, +, or - hard buttons to highlight the Home screen Tools icon
Figure 3-4. Speaker Volume Setup Screen
Figure 3-5. Speaker Volume Setup Configuration Screen
,
buttons to set desired volume.
,
to highlight the Home screen icon
and press
and press Enter
Enter and the Home
Enter
Enter
3-10