Table of Contents
Advertisement
7. Press the + or - hard buttons and choose from the leak detector list (e.g. channels #8 or #12).
8. Press Enter
Enter and the Link screen appears (Figure 3-25) for one to three seconds and then the
Enter
Enter
Home screen reappears.
3.2.5.3. MAC Address Verification
Use this screen to see the MAC addresses of both the leak detector and the wireless
remote that is communicating with the leak detector. If the MAC address of the previous
leak detector is unknown, the display leaves the leak detector MAC address blank.
To view and verify the MAC addresses from the Home screen:
1. Press the
Enter and the Speaker Volume screen appears (Figure 3-26).
Enter
Enter
Enter
Wireless Remote for Agilent Helium Leak Detector
Figure 3-24. Choose LD Screen
Figure 3-25. Link Screen
,
, +, or - hard buttons to highlight the Home screen Tools icon
Figure 3-26. Speaker Volume Setup Screen
and press
3-19
Advertisement
Table of Contents
