Universal Serial Bus; Lan1/2 (Ethernet Ports); Wake-On-Lan - Supero SUPERSERVER 6015T-INF User Manual

Universal Serial Bus (USB)
There are two Universal Serial Bus
ports located on the I/O panel and
two additional USB headers located
on the serverboard. The headers,
labeled USB2 and USB3, can be
used to provide front side USB access
(cables not included). See the tables
on the right for pin defi nitions.

LAN1/2 (Ethernet Ports)

Two gigabit Ethernet ports (designated
LAN1 and LAN2) are located beside the
VGA port on the I/O backplane. These
ports accept RJ45 type cables.

Wake-On-LAN

The Wake-On-LAN header is des-
ignated JWOL on the serverboard.
See the table on the right for pin
defi nitions. You must enable the LAN
Wake-Up setting in BIOS to use this
function. (You must also have a LAN
card with a Wake-On-LAN connector
and cable to use this feature.)
Chapter 5: Advanced Serverboard Setup
USB Ports Pin
Defi nitions (USB0/1)
Pin#
1
2
3
4
5
USB Headers
Pin Defi nitions (USB1, USB2)
USB3/5
Pin # Defi nition
1 +5V
2 PO-
3 PO+
4 Ground
5 Key
Note: NC indicates no connection.
Wake-On-LAN
Pin Defi nitions
Pin#
1
2
3
5-15
Defi nition
+5V
PO-
PO+
Ground
N/A
USB2/4
Pin # Defi nition
1 +5V
2 PO-
3 PO+
4 Ground
5 NC
(JWOL)
Defi nition
+5V Standby
Ground
Wake-up