Connecting The Control Panel; I/O Ports - Supero SUPERSERVER 6015T-INF User Manual

S S
UPER ERVER 6015T-T/6015T-INF User's Manual

Connecting the Control Panel

JF1 contains header pins for various front control panel connectors. See Figure
5-1 for the pin locations of the various front control panel buttons and LED indica-
tors. All JF1 wires have been bundled into a single ribbon cable to simplify this
connection. Make sure the red wire plugs into pin 1 as marked on the board. The
other end connects to the Control Panel PCB board, located just behind the system
status LEDs on the chassis.
5-4

I/O Ports

The I/O ports are color coded in conformance with the PC 99 specifi cation. See
Figure 5-2 below for the colors and locations of the various I/O ports.
LAN1 LAN2
USB 0/1 Ports
Note: Infi niBand ports are included on the X7DBT (6015T-INF) only. To prevent
damage to the port or serverboard, an Infi niBand bracket (included) must be used
to secure the connector to the I/O shield.
Figure 5-1. Control Panel Header Pins
20 19
Ground
x (Key)
Power On LED
IDE/SATA LED
NIC1 LED
NIC2 LED
OH/Fan Fail LED
Reserved
Ground
Ground
2
Figure 5-2. I/O Ports
COM2 Port (Turquoise)
5-4
NMI
x (Key)
Vcc 5V Stby
Vcc 3V
Vcc 3V Stby
Vcc 3V Stby
Vcc 3V
Reserved
Reset (Button)
Power (Button)
1
VGA Port (Blue)
Infi niBand Port