Control Panel Leds; Overheat/Fan Fail; Nic2; Nic1 - Supero SUPERSERVER 6015T-INF User Manual

S S
UPER ERVER 6015T-T/6015T-INF User's Manual
3-3

Control Panel LEDs

Each of the two control panels located on the front of the SC808T-980 chassis has
fi ve LEDs. Each LED provides you with critical information related its own specifi c
serverboard. This section explains what each LED indicates when illuminated and
any corrective action you may need to take.
Overheat/Fan Fail: When this LED fl ashes, it indicates a fan failure. When
on continuously it indicates an overheat condition, which may be caused by cables
obstructing the airfl ow in the system or the ambient room temperature being too
warm. Check the routing of the cables and make sure all fans are present and
operating normally. You should also check to make sure that the chassis covers
are installed. Finally, verify that the heatsinks are installed properly (see Chapter
5). This LED will remain fl ashing or on as long as the indicated condition exists.
2
NIC2: Indicates network activity on LAN2 when fl ashing .
1
NIC1: Indicates network activity on LAN1 when fl ashing.
HDD: Channel activity for the hard disk drives. This light indicates SATA
drive activity on the 6015T-T/6015T-INF when fl ashing.
3-2