lancer TouchPoint Installation Manual page 6

5. Install BIB (bag in box) connectors onto the syrup pump inlet
tubing.
! ATTENTION
Use proper connector for syrup manufacturer
A. Syrup Pump Inlet C. BIB Connector
B. Fitting
A
B
D
6. Connect syrup BIBs to connectors. Repeat for each syrup
line/pump.
Installing CO Supply
2
1. Connect high pressure CO
cylinder or bulk system.
! ATTENTION
Before installing regulator, assure that a seal (washer
or o-ring) is present in regulator attachment nut.
A
B
- Thread regulator nut on to tank, then
tighten nut with wrench
2. Connect a 1/4" nut, stem and seal to CO
3. Route appropriate tubing from the low pressure CO
regulator manifold location to the 1/4" nut, stem on the high
pressure CO regulator attached to source and connect
2
tubing.
! ATTENTION
A dedicated CO regulator is required to supply the CO
2
inlet at the unit as well as to all syrup pumps.
6
D. Oetiker Pliers
C
regulator assembly to CO
2 2
C
D
A. CO Regulator
2
B. Outlet
C. Wrench
D. CO Supply
2
regulator outlet.
2
2
B
C
4. Connect tubing routed from the CO
the low pressure CO
5. Connect tubing routed from the tee at the syrup pumps to
the second outlet of the low pressure CO
A
6. Using a wrench, loosen lock nut on the regulator adjustment
screw of the high pressure CO
source, then using a screwdriver back out lock nut screw all
the way.
! WARNING
DO NOT TURN ON CO
A
D
7. Repeat Step 6 for both low pressure CO
regulator manifold routed to the unit and the syrup pumps.
2
A. CO Regulator
A 2
B. 1/4" Nut, Stem & Seal
C. Line to CO
Manifold
D. Oetiker Pliers
D
inlet at the unit to one of
2
regulator manifold outlets.
2
regulator manifold.
2
D
A. Line to Dispenser
B. Line to Syrup Pumps
C. Line to CO
B
D. CO Regulator Manifold
2
regulator connected to the
2
SUPPLY AT THIS TIME
2
A. CO Regulator
2
B. Screwdriver
C. Loosened Lock Nut
D. Regulator Adjustment Screw
C
B
regulators on the
2
Regulator
2
C
Regulator
2