Leds; Usb Console Led - Cisco Catalyst 9300 Series Hardware Installation Manual

Product Overview
The following table lists the optional Cisco Catalyst 9300 uplink network modules with 1-Gigabit, 10-Gigabit
and 25-Gigabit slots. In addition, Cisco Catalyst 9300 Series switches also support 3850 uplink network
modules. For the complete list of supported network modules, see
Table 2: Network Modules
Network Module
C9300-NM-4G
C9300-NM-8X
C9300-NM-2Q
C9300-NM-4M
C9300-NM-2Y
C9300-NM-BLANK
1
For information about the network modules, see the
For cable specifications, see

LEDs

You can use the switch LEDs to monitor switch activity and its performance.
Figure 4: Switch Front Panel LEDs

USB Console LED

The USB console LED shows whether there is an active USB connection to the port.
1
Description
This module has four 1G SFP module slots. Any combination of standard SFP
modules are supported. SFP+ modules are not supported.
If you insert an SFP+ module in the 1G network module, the SFP+ module does
not operate, and the switch logs an error message.
This module has eight 10G slots with an SFP+ port in each slot. Each port supports
a 1G or 10G connection.
Any combination of SFP and SFP+ modules are supported.
This module has two 40G slots with a QSFP+ connector in each slot.
This module has four Multigigabit (mGig) module slots.
This module has two 25 Gigabit Ethernet SFP28 module slots.
Any combination of SFP, SFP+ and SFP28 modules are supported.
Insert this blank module when the switch has no uplink ports (this is required for
sufficient air flow).
All network modules are hot-swappable.
Cables and Adapters, on page
Network Modules Overview, on page
Installing a Network Module in the Switch, on page
101.
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
LEDs
41.
42.
7