Cisco Catalyst 9300 Series Hardware Installation Manual page 89

Configuring the Switch
Setting
Spanning Tree Mode
VTP
UDLD
Error Disable Recovery
Port Channel Load
Balance
SSH
SCP
VTY Access to Switch
Service Timestamp
VLAN
Management Interface
QoS Policy
Uplink Interfaces
Downlink Interfaces
Port-channel
Single Distribution Single Distribution
Switch (Single Downlink) Switch (Single Port
Channel Downlink)
RPVST+ RPVST+
Mode Transparent Mode Transparent
Enabled Enabled
Recovery mode set to Recovery mode set to
Auto Auto
Source Destination IP Source Destination IP
Version 2 Version 2
Enabled Enabled
Enabled Enabled
Enabled Enabled
The following VLANs are The following VLANs are
created: created:
• Default VLAN
• Data VLAN
• Voice VLAN
• Management VLAN
Layer 3 settings Layer 3 settings
configured on the configured on the
management port, based management port, based
on Quick Setup on Quick Setup
QoS Policy for QoS Policy for
Distribution defined Distribution defined
Selected uplink ports Selected uplink ports
connect to other connect to other
distribution or core distribution or core
switches switches
Downlink connections to Downlink connections to
access switches access switches
configured in Trunk mode configured in Trunk mode
Port-channel to core Port-channel to core or
created access created
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
Configuring Your Device Based on a Site Profile
Redundant Distribution
Switch (Port Channel
Peer and Downlink)
RPVST+
Mode Transparent
Enabled
Recovery mode set to
Auto
Source Destination IP
Version 2
Enabled
Enabled
Enabled
The following VLANs are
created:
• Default VLAN • Default VLAN
• Data VLAN • Data VLAN
• Voice VLAN • Voice VLAN
• Management VLAN • Management VLAN
Layer 3 settings
configured on the
management port, based
on Quick Setup
QoS Policy for
Distribution defined
Selected uplink ports
connect to other
distribution or core
switches
Downlink connections to
access switches
configured in Trunk mode
Port-channel to core or
distribution created
77