Rear Panel; Rfid Tag - Cisco Catalyst 9300 Series Hardware Installation Manual

Rear Panel

Color
Blinking amber
Amber
Rear Panel
The switch rear panel includes StackWise connectors, StackPower or XPS connectors, ports, fan modules,
and power supply modules.
Figure 6: Switch Rear Panel
1
2
3
4
5

RFID Tag

The chassis has a built-in,passive RFID tag that uses UHF RFID technology and requires an RFID reader
with compatible software. It provides auto-identification capabilities for asset management and tracking. The
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
14
Network Module Link Status
Link is off due to a fault or because it has exceeded a limit set in the switch software.
Caution Link faults occur when noncompliant cabling is connected to an SFP/SFP+/SFP28
port. Use only standard-compliant cabling to connect to Cisco SFP/SFP+/SFP28
ports. You must remove from the network any cable or device that causes a link
fault.
Link for the SFP/SFP+/SFP28 has been disabled.
USB3.0–SSD port
MGMT (RJ-45
10/100/1000 management
port)
StackWise-480 port
connectors
AC OK (input) status
LED
PS OK (output) status
LED
6 Power supply modules
7 BEACON LED
8 CONSOLE (RJ-45
console port)
9 Fan modules
10 StackPower connectors
Product Overview