Cisco Catalyst 9300 Series Hardware Installation Manual page 85

Configuring the Switch
configured according to Cisco best practices. You can easily modify this default configuration, from the
corresponding detailed configuration screens.
Choosing a site profile as part of Quick Setup allows you to configure your device based on the business needs
of your enterprise. For example, you could use your device as an access switch, to connect client nodes and
endpoints on your network, or as a distribution switch, to route packets between subnets and VLANs.
Table 31: Default Configuration Loaded with Each Site Profile (Access Switches)
Setting
Hostname
Spanning Tree Mode
VTP
UDLD
Error Disable Recovery
Port Channel Load
Balance
SSH
SCP
VTY Access to Switch
Service Timestamp
VLAN
Management Interface
IPv6 Host Policy
Single Access Switch Single Access Switch
(Single Uplink) (Single Port Channel
Uplink)
The hostname or device The hostname or device
name you provided as part name you provided as part
of Quick Setup of Quick Setup
RPVST+ RPVST+
Mode Transparent Mode Transparent
Enabled Enabled
Recovery mode set to Recovery mode set to
Auto Auto
Source Destination IP Source Destination IP
Version 2 Version 2
Enabled Enabled
Enabled Enabled
Enabled Enabled
The following VLANs are The following VLANs are
created: created:
• Default VLAN
• Data VLAN
• Voice VLAN
• Management VLAN
Layer 3 settings Layer 3 settings
configured on the configured on the
management port, based management port, based
on Quick Setup on Quick Setup
IPv6 host policy created IPv6 host policy created
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
Configuring Your Device Based on a Site Profile
Single Access Switch
(Redundant Port Channel
Uplink)
The hostname or device
name you provided as part
of Quick Setup
RPVST+
Mode Transparent
Enabled
Recovery mode set to
Auto
Source Destination IP
Version 2
Enabled
Enabled
Enabled
The following VLANs are
created:
• Default VLAN • Default VLAN
• Data VLAN • Data VLAN
• Voice VLAN • Voice VLAN
• Management VLAN • Management VLAN
Layer 3 settings
configured on the
management port, based
on Quick Setup
IPv6 host policy created
73