Installing The Switch; Rack-Mounting - Cisco Catalyst 9300 Series Hardware Installation Manual

Installing the Switch

Figure 19: Example of a Partitioned StackPower Stack with a Failover Condition

Installing the Switch

Rack-Mounting

Installation in racks other than 19-inch racks requires a bracket kit not included with the switch.
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to
ensure that the system remains stable. The following guidelines are provided to ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the
Statement 1006
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
32
heaviest component at the bottom of the rack.
unit in the rack.
Switch Installation