C9300-Nm-8X Module; C3850-Nm-4-1G Module - Cisco Catalyst 9300 Series Hardware Installation Manual

Installing a Network Module

C9300-NM-8X Module

All ports in the C9300-NM-8X module default to 10 G and should be configured as TenGigabitEthernet1/1/1
through TenGigabitEthernet1/1/8, even when you are operating them as 1 G using SFP.
Table 22: C9300-NM-8-10X Module
Interface
TenGigabitEthernet1/1/1
TenGigabitEthernet1/1/2
TenGigabitEthernet1/1/3
TenGigabitEthernet1/1/4
TenGigabitEthernet1/1/5
TenGigabitEthernet1/1/6
TenGigabitEthernet1/1/7
TenGigabitEthernet1/1/8

C3850-NM-4-1G Module

All ports in the C3850-NM-4-1G module are natively GigabitEthernet and are configured GigabitEthernet1/1/1
though GigabitEthernet1/1/4. There are only four interfaces that are valid, and the other four should not be
used even though they still show up in the CLI.
Table 23: C3850-NM-4-1G Module
Interface
GigabitEthernet1/1/1
GigabitEthernet1/1/2
GigabitEthernet1/1/3
GigabitEthernet1/1/4
TenGigabitEthernet1/1/1
TenGigabitEthernet1/1/2
TenGigabitEthernet1/1/3
TenGigabitEthernet1/1/4
Action
Configure this interface
Configure this interface
Configure this interface
Configure this interface
Configure this interface
Configure this interface
Configure this interface
Configure this interface
Action
Configure this interface
Configure this interface
Configure this interface
Configure this interface
Disregard
Disregard
Disregard
Disregard
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
C9300-NM-8X Module
47