Cables And Adapters - Cisco Catalyst 9300 Series Hardware Installation Manual

Connector and Cable Specifications
The RJ-45 console port uses an 8-pin RJ-45 connection. The supplied RJ-45-to-DB-9 adapter cable is used
to connect the console port of the switch to a console PC. You need to provide a RJ-45-to-DB-25 female DTE
adapter if you want to connect the switch console port to a terminal.

Cables and Adapters

StackWise Cables
You can order these StackWise cables (nonhalogen) from your Cisco sales representative:
• STACK-T1-50CM= (0.5-meter cable)
• STACK-T1-1M= (1-meter cable)
• STACK-T1-3M= (3-meter cable)
Table 40: StackWise Cables Minimum Bend Radius and Coiled Diameter
Cable Part Number
STACK-T1-50CM
STACK-T1-1M
STACK-T1-3M
STACK-T2-50CM
STACK-T2-1M
STACK-T2-3M
SFP Module Cables
For cabling specifications, refer to the following notes:
•
•
Each port must match the wave-length specifications on the other end of the cable, and the cable must not
exceed the stipulated cable length. Copper 1000BASE-T SFP module transceivers use standard four twisted-pair,
Category 5 cable at lengths up to 328 feet (100 meters).
Cable Length
1.64 feet (0.5 m)
3.28 feet (1.0 m)
9.84 feet (3.0 m)
1.64 feet (0.5 m)
3.28 feet (1.0 m)
9.84 feet (3.0 m)
Cisco SFP and SFP+ Transceiver Module Installation Notes
Cisco 40-Gigabit QSFP+ Transceiver Modules Installation Note
Minimum Bend Radius
2.60 in. (66 mm)
2.60 in. (66 mm)
3.58 in. (91 mm)
2.60 in. (66 mm)
2.60 in. (66 mm)
3.58 in. (91 mm)
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
Cables and Adapters
Minimum Coiled Diameter
5.20 in. (132 mm)
5.20 in. (132 mm)
7.17 in. (182 mm)
5.20 in. (132 mm)
5.20 in. (132 mm)
7.17 in. (182 mm)
101