Low Battery - Lockly Secure LUX User Manual

2.8 Low Battery

When the battery is in seriously low condition, Lockly™ will make contin-
uous beeping sounds in addition to the flashing low battery icon on the
touch screen. You should replace batteries immediately to avoid your
smart lock from shutting down.
When your smart lock low-battery warning alert finally dies, you will have
3 chances to unlock your smart lock either by a password, APP or
fingerprint. If the unlock was successful, the low-battery warning alert will
be on for 1 minute. After which, the smart lock will go to dead-battery
mode and will lock auto lock in 5 seconds and the screen will display a
low-battery icon.
Condition
Low Battery
Dead Battery
_
+
CARD
9V
Alkaline
battery
8
Indicator
Battery Icon on the
display keypad will
light up to indicate
low battery.
When there is no
display and sounds;
and screen is
non-functional.
Replace batteries immedi-
ately to avoid battery
failure. Lockly™ Secure can
still operate up to 300 cycles
in low battery condition.
Replace batteries immediately.
Supplied physical backup keys
can be used to unlock the
door. Alternatively, use a 9V
battery as shown below to
temporarily activate the lock.
Your Lockly™ will automatically
detect battery polarity. So hold your
9V battery lead in place against
bottom of the Lockly™ to temporarily
activate the screen to enter your
Access Code. Be sure to hold the
9V battery against the contact
points located at the bottom of the
lock until you have successfully
unlocked your door with your
Access Code. Once unlocked,
batteries should be replaced imme-
diately.
Solution
SECTION 2.8