Table of Contents
Advertisement
Storing recorded stills and video in the recorder
You can connect the camera to a Blu-ray recorder or DVD recorder that is compatible and
store pictures from the camera to the device.
Preparation
• Turn on the camera and recorder.
1
Connect camera to recorder
• Check the plug direction and insert it straight in. (If the cable is inserted in the
wrong direction, the plug could become deformed and cause faulty operation.)
Also, do not insert into the wrong jack. Doing so may cause damage to this unit.
• Do not use any other USB cables except a genuine Leica USB cable of the
supplied type. Using cables other than the above may cause a malfunction.
[USB/CHARGE] jack
USB cable (supplied)
2
Use
to select [PC(Storage)] and press [MENU/SET]
• If you set the [USB Mode] to [PC(Storage)] in the [Setup] menu in advance, the
camera will be automatically connected to the recorder without displaying the
[USB Mode] selection screen.
3
Dub by operating the recorder
• For details on dubbing and playback procedures, refer to the operating
instructions for the recorder.
• Some recorders may not support certain modes, such as the 4K video mode.
●
Use a sufficiently charged battery. When the battery begins to run out during communication, a
warning beep sounds. In this case, stop the transfer immediately. Otherwise, the data may be
damaged.
●
Before inserting or removing a card, turn the camera off and disconnect the USB cable.
243
Connecting with other devices
Advertisement
Table of Contents
