Adding Panels - B&D The Designer Series Installation Instructions Manual

The Designer Series & P7 Industrial

3.3 adding panels

TWO PERSON LIFT: depending on the size of
the door, this process may require two persons
to lift into place.
a) Before adding the next panel into the tracks fit a
temporary spacer, 1-2mm thick, at each panel joint
to give clearance between each panel in order to
decrease paint rub.
b) Insert the next panel into the guides and lower to
rest on top of the bottom panel. Fig 3.3.1 and 3.3.2.
c) Screw the hangers and hinged hangers to the
lowered panel.
NOTE: The hinged hangers are adjustable to ensure the
panels are parallel to the opening.
d) Repeat this procedure for all other panels with the
exception of the top panel which is positioned after
the horizontal track is installed Fig 3.3.3.
e) Once satisfied with the door placement, secure all
fixing points on the vertical tracks.
CAUTION: Ensure the warning label is placed on
the door in a clearly visible position.
installation instructions
™
Fig: 3.3.1
Fig: 3.3.2
Fig: 3.3.3
9