Intended Use; Reasonably Foreseeable Misuse; Avoiding Misuse - Optimum OPTidrill DH 28GSV Operating Manual

OPTIMUM
M A S C H I N E N - G E R M A N Y
1.3

Intended use

WARNING!
In the event of improper use of the geared drill
will endanger personnel,

will endanger the machine and other material property of the operating company,

the correct function of the geared drill may be affected.
The geared drill is designed and manufactured to be used in a non-explosive environment. The
geared drill is designed and manufactured for holes in cold metals or other non flammable
materials or that not constitute a health hazard using a rotating filing-stripping tool that has a
number of grooves for collecting the filings.
If the geared drill is used in any way other than described above, modified without authoriza-
tion of Optimum Maschinen Germany GmbH, then the geared drill is being used improperly.
We will not be held liable for any damages resulting from any operation which is not in accord-
ance with the intended use.
We expressly point out that the guarantee or CE conformity will expire due to any constructive
technical or procedural changes which had not been performed by the company Optimum
Maschinen Germany GmbH.
It is also part of intended use that
observe the limits of the geared drill,

the operating manual is observed,

the inspection and maintenance instructions are observed.


"Technical specification" on page 20
WARNING!
Extremely severe injuries.
It is forbidden to make any modifications or alternations to the operation values of the
geared drill! They could endanger the personnel and cause damage to the geared drill.
1.4

Reasonably foreseeable misuse

Any use other than that specified under "Intended use" or any use beyond that described will be
deemed non-intended use and is not permissible.
Any other use must be discussed with the manufacturer.
It is only allowed to process metal, cold and non-inflammable materials with the geared drill.
In order to avoid misuse, it is necessary to read and understand the operating instructions
before first commissioning.
Operators must be qualified.

1.4.1 Avoiding misuse


Use of suitable cutting tools.

Adapting the speed adjustment and feed to the material and workpiece.

Clamp workpieces firmly and free of vibration.
ATTENTION!
The workpiece is always to be fixed by a machine vice, jaw chuck or by another
appropriate clamping tool such as for the clamping claws.
WARNING!
Risk of injury caused by flying workpieces.
GB DH26GTV | DH28GSV | DH32GSV
Page 10 Original operating instructions
Safety
Version 1.2.5 dated 2017-03-10