Front Panel Leds - Keysight M9703B Startup Manual

Front Panel LEDs

Indicator Purpose
H/S
OOS
LA, LB,
LC, LD
STATUS Instrument
If warning or error status is observed, please try the following steps:
Power-cycle the chassis (If using a PCIe expansion chassis, observe the power
sequence requirements)
If the error persists please contact Keysight technical support
http://www.keysight.com/find/assist.
Keysight M9703B Startup Guide
Color
Hot Swap
Out Of Service
DPU status
status
State Meaning
Off Normal operating mode
Blue, blinking Initializing
Off ATCA bus is ready
Red ATCA bus is not ready
Off DPU FPGA is not configured
White Idle
White, blinking Firmware initialization in progress
Green, blinking Software initialization in progress
Orange, blinking Warning (see note below)
Red, blinking Error (see note below)
Green OK
Step 4: Install the Module
19