Keysight M9703B Startup Manual page 23

Axie high-speed digitizer

Hide thumbs Also See for M9703B:

Table of Contents

--$ AgMD2Verify <PXI51::0::0::INSTR>

4. The screen capture below shows the result of a successful verification:

AgMD2Verify checks the version of the Control FPGA firmware. If the version is

not up-to-date, the tool will automatically propose to update the firmware using

the "Firmware Update Utility". Once the Control FPGA firmware has been

updated successfully, please power off your computer and restart it again for the

update to take effect. You may then proceed with the AgMD2Verify utility as

described in this section.

If a Problem is Found

1. Verify that you have made all configuration settings as shown above.

2. Verify that the RF generator is ON and producing the desired signals at the end

of the cable. This can be done with an oscilloscope.

3. Verify that the problem is reproducible.

4. Contact Keysight technical support for assistance. Contact details may be

found at: www.keysight.com/find/assist.

Keysight M9703B Startup Guide

Step 5: Verify Operation of the M9703B Module

Table of Contents