Video Out Menu; Hdmi; H Phase (Brc-X400/X401); System Menu - Sony BRC-X400 Operating Instructions Manual

VIDEO OUT Menu

You can set [COLOR SPACE] from a web browser.
For details, see "Installation tab" (page 62).

HDMI

COLOR SPACE (Video out - Color space)
Set the color space of HDMI output.

H PHASE (BRC-X400/X401)

This feature allows you to regulate phase
differences between the external sync signal
input to the EXT SYNC IN terminal of the camera
and the video signal of the camera, when a
device which generates the synchronizing signal
is connected. The adjustment range is from 0 to
959.
The video signal is advanced in the + direction
and delayed in the – direction for the external
sync signal.
1 STEP time for [H PHASE] is 0.0135 μs.
H PHASE
This allows you to adjust by 10 STEP increments.
Choose a value from [0] to [3] to [95].
H PHASE FINE
This allows you to adjust by 1 STEP increment.
Choose a value from [0] to [9].
If you increase the value beyond 9, the tens digit
automatically increases (+1 to [H PHASE]).
If you decrease the value beyond 0, the tens digit
automatically decreases (–1 to [H PHASE]).
Notes
• [H PHASE] regulates phase differences only for
SDI OUT.
• [H PHASE] is not displayed when the SYSTEM
SELECT switch is set to 4K.
• [H PHASE] cannot be set from a web browser.

SYSTEM Menu

You can set the menu from a web browser.
For details, see "Installation tab" (page 62) or
"PTZF control tab" (page 81).
IMG FLIP (System - Image flip)
When [IMG FLIP] is set to [ON], the picture is
flipped vertically and picture shift direction by
the pan/tilt operation is also reversed.
After the [IMG FLIP] setting is changed, turn off
the camera and turn it on again to activate the
change.
Note
When the [IMG FLIP] setting is changed, the
coordinates for pan and tilt are flipped and the
following are reset.
– Pan-Tilt limit (PAN-TILT LIMIT)
– Preset
IR RECEIVE (System - IR receive)
If this is turned [OFF], the camera does not
receive signals from the supplied remote
commander.
Be sure to turn this [ON] when you use the
supplied remote commander.
Note
You cannot set [IR RECEIVE] to [OFF] when using
the supplied remote commander. To turn off [IR
RECEIVE], use the remote controller (not
supplied) or VISCA command.
TALLY LEVEL (System - Tally level) (BRC-
X400/X401)
This allows you to configure the settings related
to the tally lamp on the front of the camera.
Choose from [HIGH], [LOW], and [OFF].
[HIGH]: When the tally lamp is turned on, it
comes on bright.
[LOW]: When the tally lamp is turned on, it
comes on dim.
[OFF]: Even when the tally-lamp-ON command is
received, the tally lamp does not light up.
44