Using the VISCA RS-422 terminal
A remote controller can be connected via the
VISCA RS-422 terminal. The VISCA RS-422 allows
connections of up to 1.2 km in length.
Note
When RM-IP10 is used, make a connecting cable
using the camera and the RS-422 terminal board
connectors supplied with the remote controller.
When you make the connecting cable, refer to
the pin array of the VISCA RS-422 terminal (page
92) and the VISCA RS-422 connection diagram
(page 92).
Check the setting of each switch of the remote
controller. For details, refer to the operating
instructions of the remote controller.
Network cable (commercially
available)
* Use straight network cable.
Connecting multiple cameras to a
single remote controller (not
supplied)
Multiple cameras can be connected via the VISCA
RS-422 terminal. The VISCA RS-422 allows
connections of up to 1.2 km in length.
Note
When RM-IP10 is used, make a connecting cable
using the camera and the RS-422 terminal board
connectors supplied with the remote controller.
When you make the connecting cable, refer to
the pin array of the VISCA RS-422 terminal (page
92) and the VISCA RS-422 connection diagram
(page 92).
Check the setting of each switch of the remote
controller. For details, refer to the operating
instructions of the remote controller.
* Use straight network cables.
22
Network cable
(commercially available)
Network cable (commercially
available)
Network cable (commercially
available)