Video Out Menu; System Menu - Sony BRC-X1000/H800 Operation Instructions Manual

VIDEO OUT Menu

VIDEO MODE
This is the screen size for HDMI output. When the
signal format is 3840×2160, you can choose either
3840×2160 or 1920×1080.
COLOR SPACE
You can set the color space of HDMI output.
H PHASE (horizontal phase adjustment)
This feature allows you to regulate phase differences in
image signals from the external synchronizing signal, as
opposed to the image signal of the camera, when a
device which generates the synchronizing signal is
connected. The adjustment range is from 0 to 959.
When the video signal and the external video sync signal
are not synchronized, the video signal can be advanced
with + and delayed with –.
1 STEP time for H PHASE is 0.0135 μs.
H PHASE
This allows you to adjust by 10 STEP increments.
Choose a value from 0 to 3 to 95.
H PHASE FINE
This allows you to adjust by 1 STEP increments.
Choose a value from 0 to 9.
If you increase the value beyond 9, the tens digit
automatically increases (+1 to H PHASE).
If you decrease the value beyond 0, the tens digit
automatically decreases (–1 to H PHASE).

SYSTEM Menu

IMG FLIP (vertical flipping of the image)
When IMG FLIP is turned ON, the picture from the SDI
and HDMI outputs is flipped.
The directions of pan and tilt are also reversed. If you
change the IMG FLIP setting, turn off the camera and
turn it on again to activate the change.
Notes
• When you turn off the camera and turn it on again with
IMG FLIP turned ON, PAN REVERSE and TILT
REVERSE are turned ON. When you turn off the
camera and turn it on again with IMG FLIP turned
OFF, PAN REVERSE and TILT REVERSE are
turned off.
• If the IMG FLIP setting is changed, the coordinates
for pan and tilt are flipped and all preset values are
reset.
• If the IMG FLIP setting is changed, all content
recorded using the PTZ TRACE function is erased.
PAN REVERSE
When this is turned ON, the PAN direction is reversed.
TILT REVERSE
When this is turned ON, the TILT direction is reversed.
IR RECEIVE
If this is turned OFF, the camera does not receive signals
from the supplied remote commander.
Be sure to turn this ON when you use the supplied
remote commander.
Note
You cannot turn OFF, IR RECEIVE when using the
supplied remote commander. To turn off IR RECEIVE,
use the remote controller (not supplied) or VISCA
command.
40