Initialize Tab; System Log Tab - Sony BRC-X400 Operating Instructions Manual

Initialize tab

Initialize
Reboot
Used when forcibly rebooting the system.
When you click [Reboot], the message "This System
will be rebooted. Are you sure?" appears. Click [OK]
to reboot the camera. It takes about 2 minutes to
reboot.
Factory default
Resets the camera to the default settings.
Retain current network settings
When this is selected, the current network and
security settings can be retained even when the
camera is reset to the factory default settings.
When you click [Factory default], the message "This
System will be rebooted. Are you sure?" appears.
When you click [OK], the network indicator on the
camera starts to flash. When the default settings are
completed, the camera reboots automatically. Do
not turn off the camera before the camera reboots.
Tip
The camera can be reset to the factory default
settings by pressing the reset switch for 5 seconds or
longer.
Delete superimpose logo
Click [Delete] to delete the superimpose logo,
specified at [Position] in the Superimpose tab of the
Video menu, from the camera.
To set whether to show or hide the superimpose
logo, configure the setting in the Superimpose tab.
Save / Load
Backup setting data
Used when you save the setting data of the camera
in a file.
To save the setting data of the camera, click [Backup
setting data] and specify the destination folder
according to the instructions on a web browser.
Note
The following settings are not saved.
-Preset items (page 88)
-Network settings
Restore setting
Used when you load the stored setting data of the
camera.
Click [Choose File] to select the file in which the
setting data is stored. The camera is configured
according to the setting data.
Notes
• The following items cannot be stored or
restored in [Backup setting data] or
[Restore setting].
– Network settings
– QoS settings
– User settings
– Access limit settings
– 802.1X function settings/certificate
– SSL function settings/certificate
– Referer check settings
– Brute force attack protection settings
– Superimpose logo
– Preset settings
– Preset items (page 88)
– NDI|HX settings
• The Video codec setting is not restored if
there is an image size or frame rate that the
stored setting by changing the SYSTEM
SELECT switch cannot be applied on.
Version up
Firmware upgrade
Use this to upgrade the firmware. Click [Choose File]
to select the desired firmware file.
The confirmation dialog is displayed. Follow the on-
line instructions.

System log tab

System log
Software performance data of the camera is
recorded in the log. It includes useful data for
troubleshooting.
Click [Reload] to reload the latest data.
Log level
Set the range of data recorded in the camera.
Log size
Set the maximum number of data recorded in the
camera.
63