Pan Tilt/Zoom Menu; Video Out Menu - Sony BRC-X1000 Operating Instructions Manual

PAN TILT/ZOOM Menu

The PAN TILT/ZOOM menu is used to select the pan/
tilt/zoom mode.
RAMP CURVE (acceleration/deceleration
curve)
You can set the acceleration/deceleration curve for pan
and tilt.
MODE1: The camera accelerates/decelerates quicker
than MODE2.
MODE2: This is the standard acceleration/deceleration
curve.
MODE3: The camera accelerates/decelerates slower
than MODE2.
PAN TILT SLOW (slow pan/tilt)
You can select slow speed panning/tilting.
OFF: The camera pans/tilts at the standard speed.
ON: The camera pans/tilts slower if the supplied remote
commander is used.
The minimum speed is the same when the remote
controller (not supplied) or VISCA command is
used. However, the faster the speed, the greater
the difference between ON and OFF.
CLEAR IMAGE ZOOM
You can set the range of zooming.
OFF: This restricts zooming only to optical zooming.
ON: This allows zooming within the range of optical
zooming and clear image zooming.

VIDEO OUT Menu

VIDEO MODE
This is the screen size for HDMI output. When the
signal format is 3840 × 2160, you can choose either
3840 × 2160 or 1920 × 1080.
COLOR SPACE
You can set the color space of HDMI output.
H PHASE (horizontal phase adjustment)
This feature allows you to regulate phase differences in
image signals from the external synchronizing signal as
opposed to the image signal of the camera when a device
which generates the synchronizing signal is connected.
The adjustment range is from 0 to 1919 STEP.
When the video signal and the external video sync signal
are not synchronized, the video signal can be advanced
with + and delayed with –.
You can make adjustments with the following
H PHASE and H PHASE FINE settings.
H PHASE
This allows you to adjust by 10 STEP increments.
Choose a value from 00 to 03 to 191.
H PHASE FINE
This allows you to adjust by 1 STEP increments.
Choose a value from 0 to 9.
If you increase the value beyond 9, the tens digit
automatically increases (+1 to H PHASE).
If you decrease the value beyond 0, the tens digit
automatically decreases (–1 to H PHASE).
39