Sony BRC-X400 Operating Instructions Manual page 18

Attach the wire
rope.

M 3×8

(supplied)
Lightly tighten screws temporarily in the
order indicated in the figure.
Afterwards, screw each of them firmly.
CAUTION
Use the supplied screws. Otherwise, you
may break the internal parts of the camera.
4
Insert the protrusions raised on the ceiling
bracket (A) into the spaces prepared in the
ceiling bracket (B), and temporarily attach
them by pushing the ceiling bracket (A) to
the rear.
Ceiling
bracket (B)
Ceiling


Ceiling
bracket (A)
Ceiling
Ceiling bracket
(A)
5
While pushing up the entire camera, attach
it to the ceiling bracket (B) using the 3
screws (M3 × 8) supplied.
Ceiling
Lightly tighten screws temporarily in the
order indicated in the figure. Afterwards,
screw each of them firmly.
6-1
Connect the cables to the terminals at the
back of the camera.
Ceiling
Notes
• Make sure no load is applied to the
connectors of the cables.
• For measures that prevent the HDMI cable
from being pulled out, proceed to "6-2"
after connecting the HDMI cable. Then,
connect all the other cables.
6-2
To prevent the HDMI cable from coming off,
mount the HDMI cable fixing plate with the
supplied screw (single, M2.6 × 6, black) on
the back of the camera, then fix the HDMI
cable with a banding band etc.
18


M 3 × 8
(supplied)
